Get ready to pass the D-PVM-OE-23 Exam right now using our Dell Storage Exam Package
A fully updated 2024 D-PVM-OE-23 Exam Dumps exam guide from training expert itPass4sure
NEW QUESTION # 93
What are the EMC Virtual Storage Integrator requirements for VMAX All Flash and VMAX3 arrays?
- A. Array must be registered, EMC SMI-S Provider, and Masking Views for the ESX/ESXi hosts must exist on the array
- B. Array must be registered, EMC VSS Provider, and EMC Unisphere for VMAX
- C. EMC SMI-S Provider, EMC Unisphere for VMAX, and EMC VSS Provider
- D. Masking Views for the ESX/ESXi hosts must exist on the array, EMC Storage Plug-in, and EMC Solutions Enabler
Answer: D
NEW QUESTION # 94
Based on the graphic, why would an administrator use the symsan command on the local array before configuring remote replication?
- A. Verify the devices on the local array are visible on the remote array
- B. Verify the port maintaining the link to the remote array is Fibre-switched and online in order to create the first Dynamic SRDF group
- C. Verify the zoning from the local array to the remote array is performed correctly
- D. Verify the local director and ports are set to Fibre-switched and offline in order to create the first Dynamic SRDF group
Answer: C
NEW QUESTION # 95
Which function was removed with PowerMaxOS?
- A. Service Levels
- B. Workload Types
- C. Host I/O Limits
- D. Quality of Service
Answer: B
NEW QUESTION # 96
What will happen if one or more source (R1) devices in an SRDF/Synchronous Consistency Group cannot propagate data to their corresponding target (R2) devices?
- A. SRDF/S replication will be suspended and a consistent data cleanup will be performed on the R2 targets
- B. All RDF device pairs in the Consistency Group will be set to Not Ready
- C. Data propagation from all R1 devices in the Consistency Group to the R2 targets will be suspended
- D. Data propagation from the specific R1 devices to their corresponding R2 targets will be suspended
Answer: C
NEW QUESTION # 97
Where is data compression enabled on a VMAX All Flash array?
- A. Disk Group
- B. Data Pool
- C. Storage Group
- D. Thin devices
Answer: C
NEW QUESTION # 98
What is the correct sequence of steps to obtain PowerMax licenses and ensure the PowerMax is configured to allow the licensed features to work properly?
Answer:
Explanation:
NEW QUESTION # 99
Which director emulation can be added to a VMAX3 array using Solutions Enabler?
- A. DX - Disk eXterna
- B. IM - Infrastructure Management
- C. DS - Back-end
- D. FA - Fibre Channel front-end
Answer: D
NEW QUESTION # 100
Which VMAX3 objects can be configured with Unisphere for VMAX and SYMCLI?
- A. Disk groups, Data Pools, and Storage Resource Pools
- B. Thin devices and autoprovisioning groups
- C. Thin devices, Storage Resource Pools, and Masking Views
- D. Disk groups, Data Pools, and autoprovisioning groups
Answer: B
NEW QUESTION # 101
What is the function of FAST hinting on a VMAX3 array?
- A. Sends hints to the array for low access data to be compressed
- B. Sends hints to the array for data that is likely to be accessed in a given period of time
- C. Provides suggestions for manual movement of data to other tiers
- D. Provides suggestions for data migration activities to be performed on stale data
Answer: B
NEW QUESTION # 102
What needs to be created in Unisphere for PowerMax before any TimeFinder SnapVX operation?
- A. Storage Group
- B. Consistency Group
- C. Device Group
- D. Masking View
Answer: A
NEW QUESTION # 103
Which SRDF/A feature keeps sessions active in the event of a temporary link loss?
- A. Write Folding
- B. Multi-Cycle Mode
- C. Group-level Write Pacing
- D. Transmit Idle
Answer: D
NEW QUESTION # 104
Where are VMAX3 SRDF/A Delta Set Extension (DSE) allocations stored?
- A. Cache
- B. Default SRP
- C. DSE pool
- D. Fastest disk pool
Answer: B
NEW QUESTION # 105
What is the maximum number of engines that can be configured on a VMAX 200K array?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 106
At which level should the SLO be associated to have a device managed by FAST on a VMAX3?
- A. Data Pool
- B. Storage Group
- C. Masking View
- D. Device Group
Answer: C
NEW QUESTION # 107
In a Unisphere for VMAX remote deployment, Unisphere cannot discover any storage arrays.
What could be causing this issue?
- A. An IP configuration or LAN issue on or between the Unisphere server and the SYMAPI server may exist.
- B. An FC configuration or SAN issue on or between the Unisphere client and the SYMAPI server may exist.
- C. Unisphere client is not directly connected to a VMAX3.
- D. Unisphere server is not directly connected to a VMAX3.
Answer: B
NEW QUESTION # 108
Where is the automatic backup feature for the Solutions Enabler Group Name Services (GNS) database set?
- A. SYMAPI options file
- B. Installation wizard
- C. Daemon options file
- D. Unisphere for VMAX
Answer: C
NEW QUESTION # 109
An administrator is using Unisphere for PowerMax Workload Planner to assess the performance and compliance of a PowerMax Storage Group (SG).
How does the Planner calculate if the Storage Group workload is stable?
- A. Both calculated values are within the SL-defined response time
- B. One of the calculated values remains within the SL-defined response time
- C. Both calculated values are within a 10-15% threshold of the SL-defined response time
- D. One of the calculated values is within 10-20% of the SL-defined response time
Answer: C
NEW QUESTION # 110
On a VMAX All Flash, what is the minimum user role required to setup thresholds to monitor array operations?
- A. Auditor
- B. StorageAdmin
- C. PerfMonitor
- D. StorageAdmin
Answer: C
NEW QUESTION # 111
Which Solutions Enabler daemon is responsible for Gatekeeper management?
- A. storgnsd
- B. storsrvd
- C. storstpd
- D. storapid
Answer: D
NEW QUESTION # 112
You are performing a non-disruptive migration between two arrays within the same data center.
What is the maximum number of concurrent migration sessions?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 113
What does Solutions Enabler use to determine the lockbox Stable System Values during installation?
- A. Host hardware characteristics
- B. User-defined password
- C. Date of the installation
- D. Installation license
Answer: A
NEW QUESTION # 114
......
Master 2024 Latest The Questions Dell Storage and Pass D-PVM-OE-23 Real Exam!: https://www.itpass4sure.com/D-PVM-OE-23-practice-exam.html
Practice To D-PVM-OE-23 - itPass4sure Remarkable Practice On your Dell PowerMax and VMAX Family Solutions Operate 2023 Exam: https://drive.google.com/open?id=18oa4qG6Tuv5E-NvJOGR50P58h0gb2mrX
