F5 New 2022 301a Sample Questions Reliable 301a Test Engine
Feel F5 301a Dumps PDF Will likely be The best Option
NEW QUESTION 70
An unwanted IP address tries to connect to the configuration utility via Self IP An LTM Specialist needs to block the attempts based on the IP address.
How should the ITM Specialist block the attempts without affecting other users?
- A. SSH IP allow list
- B. Port lockdown
- C. Device trust
- D. Packet filter
Answer: D
NEW QUESTION 71
A web application is configured as follows:
What should be modified to set a maximum request limit?
- A. Pool settings
- B. Virtual server settings
- C. ICP Profile
- D. HTTP profile
Answer: D
NEW QUESTION 72
A Client makes the request displayed below to the application server.
Which virtual server type should an LTM Specialist use to load balance based on the URI?
.
- A. Standard
- B. Forwarding (Layer 2)
- C. Performance (Layer 4)
- D. Stateless
Answer: A
NEW QUESTION 73
An ITM Specialist has the configuration shown:
The LTM Specialist needs to create a new virtual server in part B.
Which virtual address(es) should be used for the new virtual server?
- A. 10.100.0.1 and.10.120.0.1
- B. 10.90.0.1 and 10.100.0.1
- C. 10.90.0.1 and 10.12.0.1
- D. 10.120.0.1 only
Answer: A
NEW QUESTION 74
Refer to the exhibit.
An LTM Specialist configures the two syslog destination Syslog destination #1 can receive messages but the syslog destination #2 can NOT receive messages.
Which command sill correct the issue?
- A. {/Common)(tmos) # modify Ays syslog remote servers modify {syslog_dest2 {local- ip 10.208.102 254)}
- B. {Common(tmos) # modify/syslog remote-servers modify {syslog_dest2 {lost.10.10.10.28 }}
- C. {/Common) (tmos) # modify /sys syslog remote-servers modify {syslog_dest2 {host 10 208.102.254 }}
- D. {/Common)(tmos) # modify /syssyslog remote-servers modify (syslog_dest2 {local-ip
Answer: D
NEW QUESTION 75
A company plans to launch a huge marketing campaign and expects increase demand of their secure website. With the current virtual server setup, the LTM Specialist expects that the LTM device will reach its capacity limits. For the wen application to function properly. Cookies persistence is required. The LTM Specialist needs to reduce LTM device load without breaking the application.
Which two settings should the LTM Specialist modify to meet the requirement? (Choose two.)
- A. Remove web acceleration profile.
- B. Remove HTTP profile
- C. Remove ClientSSL profile
- D. Modify virtual Server type to performance (Layer 4)
- E. Remove HTTP compression profile
Answer: A,E
Explanation:
It is required that cookie persist must be used and http profile must be used, and SSL offloading must also be required. It must be in standard mode, excluding BD E.
NEW QUESTION 76
An LTM Specialist is removing some of the load off an existing cluster by adding a adding a third BIG-IP device to the device group. The new device can deliver twice the performance of the other two devices.
The LTM Specialist needs to make sure that the BIG-IP device with the highest available capacity is always selected to take over a traffic group in the event of a failover.
Which failover method is most appropriate?
- A. HA Group
- B. Load Aware
- C. HA Capacity
- D. Ordered List
Answer: D
NEW QUESTION 77
AN LTM Specialist needs to determine the delay between an LTM device and the internal web server for a specific client.
Which two AVR reporting options should the LTM Specialist enable to measure the delay? (Choose two.)
- A. Server latency
- B. Methods
- C. User agents
- D. Client IP
The problem is to specify the server delay of the client - E. Response codes
Answer: A,D
NEW QUESTION 78
A virtual server is configured to handle https traffic. The clientssl profile is configured to use a2048-bit RSA key. Due to security requirements, is the LTM Specialist needs to use a 4096-bit RSA key in the future.
What two effects will this change have on the BIG-IP device? (Choose two)
- A. Increased of concurrent connection on client-side
- B. Increase of TLS Renegotiation
- C. Decrease to 20% of licensed TPS
- D. Decrease to 90% of licensed TPS
- E. Increase of CPU usage on the BIG-IP device
Answer: C,E
NEW QUESTION 79
A pool with a default connection limit is configured to use Round Robin as the load balancing method. An LTM Specialist needs to ensure that the LTM device selects a server with the fewest number of connections when new clients connect. Another pool is using the same set of backend servers.
Which load balancing-method should the pool be changed to?
- A. Weighted Least Connections (node]
- B. Least Connections
- C. Weighted Least Connections (member)
- D. Least Connections
Answer: D
NEW QUESTION 80
AN LTM Specialist is using an external monitor evaluate the hard drive usage of a node. The monitor has marked the node down because it exceeded the specific threshold. The disk usage on the server has been corrected below the threshold, however, the node remains offline.
Which feature is causing this problem?
- A. The value for UP interval is enable with a value greater than 0
- B. The value for Manual Resume is set to Yes
- C. The parameter Time Until UP has a value greater than 0
- D. The value of Manual Resume is set to No
Answer: B
NEW QUESTION 81
An LTM Specialist needs to create a virtual server to pass TCP traffic to three pool members.
Which two virtual server types should be used to meet the requirements? (Choose two)
- A. Standard
- B. Forwarding (Layer 2)
- C. Stateless
- D. Forwarding (IP)
- E. Performance (Layer A)
Answer: A,E
NEW QUESTION 82
An LTM Specialist has trouble with SNMP traps in the management network The ITM Specialist takes the network capture shown to troubleshoot:
What should the UM Specialist change to capture packets related to this workflow?
- A. the port
- B. the verbose level
- C. the interface
- D. the tcpdump filter expression
Answer: C
NEW QUESTION 83
An LTM Specialist must create a new virtual server for HTTP access. The LTM Specialist creates a forwarding virtual server to reach the resource.
What is a potential result of this action?
- A. Packet filter allowances are also required
- B. HTTP traffic is NOT allowed
- C. Other service ports could be allowed
- D. IP conflict result
Answer: B
NEW QUESTION 84
An LTM device needs an additional traffic group.
Which configuration item is required?
- A. Auto Fallback Timeout
- B. MAC Masquerade Address
- C. Default device
- D. Group name
Answer: D
NEW QUESTION 85
An LTM Specialist needs to assign a health monitor to a pool with two pool members 10.10.10 101 and 10.10.10.102 Both pool members are listening on port 8080 with TCP. The health of the application depends on the health of an another server (10 10 10 100) that runs port 9080 with TCP.
Which two custom TCP monitors should be selected as the pool's health monitors' (Choose two)
- A. a custom TCP monitor that works on port 9080 with 10.10.10.100 as alias address
- B. a custom TCP monitor that works on port 9080 with 10,10.10.101 as alias address
- C. a custom TCP monitor that works on port 8080
- D. a custom TCP monitor that works on port 9080,
- E. a custom TCP monitor that works on port 8080 with 10.10.10.101 as alias address
- F. a custom TCP monitor that works on port 8080 with 10.10.10.102 is alias address
Answer: A,C
NEW QUESTION 86
One LTM device in an HA pair of LTM devices is unable to reach its default gateway. An HA Failover event needs to happen.
Which configuration item enables this behavior?
- A. Gateway pool monitor
- B. iRule
- C. Gateway Fail Safe
- D. Gateway pool
Answer: C
NEW QUESTION 87
......
Introduction to F5 301a: BIG-IP LTM Specialist: Architect Set-Up & Deploy Exam
The eligible applicant is capable of using TMOS-based systems that have already been developed on a daily basis. They may also perform simple troubleshooting on a TMOS-based system in order to provide senior engineers and/or F5 Support with full, correct, and relevant details.
They are capable of completing all of the following tasks without assistance:
- On the platform, execute information administration tasks (for example, capable of performing upgrades and licensing).
- Use the GUI to perform administrative tasks - Recognize the differences and relationships among virtual servers, virtual server forms, virtual addresses, pools, pool participants, nodes, profiles, iRules, and address translation (NAT/SNAT).
- Open a help case and use online tools like AskF5, F5 iHealth, and DevCentral to learn about HTTP, ClientSSL, ServerSSL, TCP, UDP, and persistence profiles.
- Able to use different paths to connect and control the BIG-IP (management IP, Self IP)
Use Valid New 301a Test Notes & 301a Valid Exam Guide: https://www.itpass4sure.com/301a-practice-exam.html
301a exam torrent F5 study guide: https://drive.google.com/open?id=1Rh_7aNXt13cUsB1KoHtQFioJS33FOAvU
