[Dec 22, 2021] NS0-161 Exam Dumps - 100% Marks In NS0-161 Exam!
Exam Dumps Use Real NetApp Certified Dumps With 62 Questions!
NEW QUESTION 29
You have a new AFF A400 with a switched 10 GbE cluster interconnect.
Referring to the exhibit, which statement is true about utilizing free ports on slot 3 for the data connection?
- A. The ports in slot 3 cannot be used in any scenario.
- B. Free ports can be used as a 10 GbE connection.
- C. Ports in slot 3 can be used for 40/100 GbE data connections.
- D. Slot 3 is used as the acceleration card and the cluster interconnect.
Answer: B
NEW QUESTION 30
Your company is merging with another company. You are asked to setup your AFFA 400 cluster to support two networks that have the same overlapping 192.168.1.0/ 24 subnet.
In this scenario, what must you create, to enable the same subnet with overlapping IPs on the same cluster?
- A. IPspace
- B. broadcast domain
- C. failover group
- D. subnet
Answer: A
NEW QUESTION 31
A customer installed an ONTAP cluster. The customer wants to provide data access to host computers and end users.
Which three tasks are required? (Choose three.)
- A. Create an IPspace.
- B. Create a LIF.
- C. Create a volume.
- D. Create an SVM.
- E. Create a Quality of Service (QoS) policy.
Answer: B,C,D
NEW QUESTION 32
Click the Exhibit button.
You configured LACP between a 2-node AFF 220 system and two Ethernet switches using multichassis Ether- channel for redundancy. You sent the network connection diagram in the exhibit to your network team to cable and configure the switch. You noticed partial connectivity on the AFF A220 for the interface groups.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. ONTAP does not have a multichassis Ether-channel feature.
- B. The network team forgot to verify the port channel members.
- C. 10 GbE ports are not supported with the AFF A220.
- D. The storage cabling to the switches is incorrect.
Answer: A,D
NEW QUESTION 33
Click the Exhibit button.
A customer has an issue with performance on an NVMe solution. The SVM is using all four ports shown in the exhibit.
In this scenario, how would the customer improve the host performance? (Choose the best answer.)
- A. Change the SFP+ in the controllers from 32 Gbps to 64 Gbps.
- B. Remove support of the FC protocol and only use NVMe.
- C. Move all of the network interfaces to port 2a.
- D. Move some of the network interfaces from 2a to 2c and 2d.
Answer: D
NEW QUESTION 34
You have an ONTAP 9.7 cluster. You increased the size of the volume to 3 TB, but the IOPs did not increase as expected.
What are the expected IOPS for the volume after the change?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 35
What are two advantages of creating small RAID groups inside an aggregate? (Choose two.)
- A. shorter reconstruction time
- B. maximized storage space
- C. decreased risk of multiple disk failure
- D. additional available spare drives
Answer: A,C
NEW QUESTION 36
You have a mix of FAS8200s and AFF A700s in your environment.
In this scenario, which two statements are true? (Choose two.)
- A. Inline aggregate-level deduplication is enabled by default on AFF systems.
- B. Inline data compaction is disabled by default on FAS systems.
- C. Inline aggregate-level deduplication is enabled by default on FAS systems.
- D. Inline data compaction is disabled by default on AFF systems.
Answer: A,B
NEW QUESTION 37
Which two components are required for committing data to a WORM volume? (Choose two.)
- A. You must license SnapLock.
- B. You must create a SnapLock volume.
- C. You must create a SnapLock Aggregate.
- D. You must create a SnapLock SVM.
Answer: B,C
NEW QUESTION 38
You have a new ONTAP 9.7 2-node AFF A300 cluster with 2x DS224C full shelves of 3.8 TB encrypted SSDs.
In this scenario, which statement matches the factory disk-ownership setting? (Choose the best answer.)
- A. All drives on shelf 1 are assigned to one node, and all drives on shelf 2 are assigned to the partner node.
- B. All even-numbered drives on each shelf are assigned to one node, and all odd-numbered drives on each shelf are assigned to the partner node.
- C. Disk ownership is not assigned by the factory.
- D. Drives 0-11 on each shelf are assigned to one node, and drives 12-23 on each shelf are assigned to the partner node.
Answer: D
Explanation:
Explanation
https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.cdot-fcsan-optaff-sg%2FGUID-D29E0355 The factory configures the SAN optimized configuration using values that have been tested and found to be optimal for AFF clusters
NEW QUESTION 39
You are asked to deploy a two-node ONTAP Select system. The physical hardware is located in two different locations. You must ensure high availability and automated switchover.
Which two steps would you take to satisfy this requirement? (Choose two.)
- A. Ensure that the ONTAP Select Deploy VM resides at a third location other than the two datacenters.
- B. Ensure that the SyncMirror license is installed on the cluster.
- C. Use ONTAP Select Deploy to install the nodes on the physical hardware.
- D. Use Active IQ Unified Manager to provide a quorum for the two nodes.
Answer: A,C
Explanation:
https://docs.netapp.com/us-en/ontap-select/concept_ha_config.html
NEW QUESTION 40
Click the Exhibit button.
The exhibit displays the values for the default adaptive QoS policy. An administrator assigns the Value policy to a 1 TB volume. Over time, the volume expands to 3 TB.
What is the peak IOPS for the volume, both before and after the expansion? (Choose the best answer.)
- A. 75 IOPS and 512 IOPS
- B. 512 IOPS and 512 IOPS
- C. 512 IOPS and 1536 IOPS
- D. 512 IOPS and 12288 IOPS
Answer: D
NEW QUESTION 41
Your ONTAP 9.7 cluster failed a security audit on the management control plane. Your network security team asked you to allow only cluster1 and SVM1 management on the 192.168.1.0/24 subnet.
In this scenario, where do you apply the default-management service policy shown in the exhibit?
- A. DNS
- B. port
- C. firewall
- D. LIF
Answer: D
NEW QUESTION 42
Which statement is true about creating volumes that contain LUNs?
- A. You cannot create LUNs on an SVM root volume.
- B. You cannot create add files on a volume that contains LUNs.
- C. You cannot create qtrees on a volume that contains LUNs.
- D. You can create LUNs on an aggregate.
Answer: A
NEW QUESTION 43
Click the Exhibit button.
You are configuring your tape backup software to authenticate to your single-node cluster by using NDMP. Referring to the exhibit, which LIF do you use to connect? (Choose the best answer.)
- A. cluster1-01_ic1
- B. data_lif1
- C. cluster-01_mgmt1
- D. cluster_mgmt
Answer: A
NEW QUESTION 44
Which ONTAP feature uses the Service Processor to speed up takeover times between HA pairs?
- A. cluster HA
- B. hardware-assisted takeover
- C. epsilon
- D. automatic takeover and giveback
Answer: B
NEW QUESTION 45
Click the Exhibit button.
You have a 2-node cluster cabled as shown in the exhibit. You want to convert the cluster to a switched cluster.
Which two statements are true in this scenario? (Choose two.)
- A. The conversion is disruptive.
- B. After the conversion, traffic to the intercluster LIFs will flow through the cluster switch.
- C. The conversion is non-disruptive.
- D. After the conversion, traffic to the cluster LIFs will flow through the cluster switch.
Answer: C,D
NEW QUESTION 46
When a write from a SAN host is received, the information is stored within the controller before it is written to the underlying RAID. In this scenario, which component stores the data?
- A. Flash Pool
- B. NVRAM
- C. HBA
- D. FlashCache
Answer: B
NEW QUESTION 47
You are configuring an ONTAP cluster to use NVMe/FC.
In this scenario, which two statements are true? (Choose two.)
- A. Create and start the FC service.
- B. Create an SVM with NVMe enabled.
- C. Create NVMe LIFs on FC target ports.
- D. Create an SVM with both NVMe and FC protocols enabled.
Answer: A,D
Explanation:
Explanation/Reference: https://www.netapp.com/pdf.html?item=/media/10681-tr4684pdf.pdf
NEW QUESTION 48
You are asked to investigate possible solutions for increasing the performance of a read-intensive, NFSv3 workload in your FAS environment.
Which two NetApp technologies would satisfy the requirement? (Choose two.)
- A. FlexCache
- B. Flash Pool
- C. FlexVol
- D. FabricPool
Answer: A,B
NEW QUESTION 49
When deploying NVMe/FC, what must be supported and enabled on the host to ensure proper multipathing?
(Choose the best answer.)
- A. NVMe Qualified Names (NQN)
- B. single initiator multiple target zoning
- C. Asynchronous Namespace Access (ANA)
- D. Asymmetric Logical Unit Access (ALUA)
Answer: C
NEW QUESTION 50
On FAS systems, FlexCache volumes are typically used for which type of workload?
- A. write-intensive NAS workloads
- B. read-intensive SAN workloads
- C. write-intensive SAN workloads
- D. read-intensive NAS workloads
Answer: D
NEW QUESTION 51
An administrator forgot to update the cabling sheet for a core Cisco switch and cannot recall which ports were used by the NetApp FAS system.
Which command should the administrator run to obtain this information?
- A. network interface show
- B. network port show
- C. network port broadcast-domain show
- D. network device-discovery show
Answer: D
NEW QUESTION 52
You are asked to separate replication and data traffic into their own individual VLANs. You created two new VLANs and need to create logical interfaces (LIFs).
In this scenario, what must you do before creating the LIFs? (Choose the best answer.)
- A. Create an interface group.
- B. Create a broadcast domain.
- C. Create a network subnet.
- D. Create a firewall policy.
Answer: B
NEW QUESTION 53
......
What is the duration, language, and format of Network Appliance NS0-161: NetApp Certified Data Administrator ONTAP Exam
- In countries where English is not the native language, candidates for whom English is not their first language will be granted a 30-minute extension to the allotted examination completion time.
- This exam consists of 60 questions
- This exam is offered in only English
- To take the Netapp certification NS0-161 exam, you have at least 6-12 months of field experience administering NetApp data management solutions in the cloud. The NetApp Certified Data Administrator ONTAP NS0-161 exam test includes 60 test questions, with an allotted time of 1-1/2 hours to complete. In countries where English is not the native language, candidates for whom English is not their first language will be granted a 30-minute extension to the allotted examination completion time.
- There is a time limit of 100 minutes for the exam
Pass Your NS0-161 Exam Easily With 100% Exam Passing Guarantee: https://www.itpass4sure.com/NS0-161-practice-exam.html
